
Engineered airflow for the MK1
For 15 years Scientific Rabbit has taken a strictly data-driven approach to VW performance. Every part is flow-benched, dyno-tested and proven before it’s sold. Today we build precision 3D-printed cold-air intake systems for the MK1, for factory CIS and modern engine swaps.
Cold-air kits for the MK1 chassis
Printed in high-temperature ASA to survive engine-bay heat. Each kit bolts into factory mounting points: no cutting, no welding.

CIS Big Bore Kit
Replaces the restrictive 2.25" factory lower air box with a 3D-printed 3" big-bore box and a matching cold-air elbow that draws from under the radiator.

ABA Swap Air Box
Replaces the usual pod filter in ABA swaps with a sealed box that draws cold air from the fender well and feeds the MAF through a correctly sized bell-mouth entry.

AEG Swap Air Box
Uses the original MK1 CIS air box mounts and the factory under-radiator cold-air inlet, with the lid outlet aimed straight at the passenger-side AEG throttle body.
Tested. Proven. Then sold.
Forums are full of “performance upgrades” that aren’t worth the page they’re printed on. We only sell parts that measurably deliver.
Hypothesis
Find the real restriction: inlet size, runner imbalance, hot intake air.
Flow bench
Measure every runner and passage, before and after, in inches of water.
Dyno
Back-to-back chassis-dyno runs with nothing else changed, not even the oil.
Publish
Share the results, good or bad, so you can decide with real numbers.
The data behind the parts

MK1 Ported Intake Manifold
A controlled before-and-after chassis-dyno test of a Stage 1 ported A1 intake manifold, followed by Stage 3 results on an SCCA race car and a 225 whp supercharged Rabbit.

MK3 vs. MK4 8-Valve Intake Manifold
Back-to-back testing of stock and fully ported MK3 and MK4 8-valve manifolds on an ABA-swapped Corrado. The MK4 manifold gained low-end torque; porting the MK3 didn't help.

3" CIS Big Bore Cold Air Box
Does a bigger CIS lower air box that only breathes cold outside air make power, or at least not lose any? A back-to-back dyno test on a 1983 GTI.
MK1 A/C blower motor adapter
The Lab is our open R&D workshop: early prototypes, fabrication experiments and engineering projects straight off the workbench, before they reach production.
Inside the lab



Have a build in mind?
Tell us about your car and engine, and we'll help you choose the intake kit that fits best.
