Installed in an ABA-swapped MK1.
The pod filter found on most ABA swaps has two problems. It breathes hot engine-bay air, and it gives the MAF a poor, turbulent entry, which affects how accurately the ECU meters fuel.
This kit fixes both. The sealed box pulls air from the right fender wheel well, and the outlet uses the correct diameter and length with a small bell-mouth entry ahead of the MAF.
It is a true drop-in: no welding, drilling or other permanent changes, and installation takes about 20 minutes.
Why it works
Cold air, not engine-bay air
Draws from the right fender wheel well instead of the hot engine bay.
Proper MAF entry
Correct diameter and length with a bell-mouth entry for smooth flow into the MAF.
No permanent changes
No welding, drilling or cutting. Bolts in and can be reversed.
Quick install
Typically about 20 minutes.
Made for engine-bay heat
High-temperature ASA construction.
What’s included
- 3D-printed air box and lid
- Cold-air inlet ducting
- Mounting hardware
Specifications
- Engine
- 2.0 ABA
- Mount
- Passenger side
- Air source
- Right front wheel well
- Material
- High-temperature ASA
- Install time
- ≈ 20 minutes
What the data says
Owner feedback so far: noticeably better throttle response than the pod filter it replaced. Back-to-back dyno and intake-temperature logging are planned and will be published here.
Other kits

CIS Big Bore Kit
Replaces the restrictive 2.25" factory lower air box with a 3D-printed 3" big-bore box and a matching cold-air elbow that draws from under the radiator.

AEG Swap Air Box
Uses the original MK1 CIS air box mounts and the factory under-radiator cold-air inlet, with the lid outlet aimed straight at the passenger-side AEG throttle body.
Ready to order the ABA Swap Air Box?
Tell us about your car and we'll confirm fitment before invoicing.
